上海哪里有鲍米勒伺服驱动器910故障维修商家:910：Overspeed detected at set value input: 在设定值输入处检测到超速：In the operating mode speed control or speed setting a set value was written exceeding the maximum interpolating speed set value of the set value manager. Refer to Z110.3– Output for details. 在运行模式下，速度控制或速度设置设定值写入的内容超过了的最大插值速度设置值设定值管理器。有关详细信息，请参阅Z110.3–输出。
Set values were written in the operating mode Position Control (-4) that either exceed the set speed limit (Parameter Z121.11–), the allowed maximum speed of the motor (Parameter Z107.26–) or max. interpolatable set value speed.设定值是在操作模式下写入的位置控制（-4）超过设定的速度限制（参数Z121.11-）电机允许的最大速度（参数Z107.26-）或最大可插值设定值速度。
The error is displayed and the set value speed is limited (Z121.11–and Z107.26– respectively) at error response „No response“. Therefore the input position and the output position drift away.在错误响应“无响应”时，显示错误并限制设定值速度（分别为Z121.11-和Z107.26-）。因此，输入位置和输出位置偏移。
A speed (= master shaft speed) was recognized at the encoder input in operating mode synchronous operation (-5), which leads to an overflow at the encoder output with the set gear ratio. The error is displayed and the drive tries to reduce the speed to the allowed limit at error response „No response“.在操作模式同步操作（-5）中，编码器输入处识别出速度（=主轴速度），这导致在设定传动比的情况下编码器输出处溢出。显示错误，驱动器试图在错误响应“无响应”时将速度降低到允许的极限。
Other error responses: 其他错误响应：
The active operating mode will be terminated and the drive will be decelerated according to the preset error response。The error can be reset at any time.
主动操作模式将终止，驱动器将根据预设的错误响应减速该错误可以随时重置。
转载请注明出处：上海仰光电子科技专业伺服驱动器维修,伺服电机维修
本文链接：/fuwu/Services_Show21548.htm
伺服驱动器维修 伺服电机维修 触摸屏维修 变频器维修
电话：021-50157782
手机：13817011982 微信同号
邮箱：shygdzi@163.com
联系人：张工
网址：
【 我们确保修好测试好给客户！！！！】
下一篇：东曹凝胶渗透色谱仪HLC-8321GPC常见故障维修方法
